Gluing Instructions for "Arena"; Slabs
Arena slabs and corners are produced on a base of synthetic plaster for application inside of accommodations. They are connected “on eye” and therefore not needing fugue and this also decreases cost and time and the cutting of slabs is not a problem. The difference in sizes and tints gives the elevation a natural appearance.
It belongs to check the slabs before laying them down. The firm does not take responsibility for incorrect installment of the slabs on wall. Reclamations concerning size and colors are not taken into consideration after installment.

Slabs should be glued on clean, dried and equal leveled surface when applying proper glue for given basis (“Elastic” or “Gipsolep”). If necessary the glued surface can be given a layer of clearcole (water-soluble). Basis must be stable and transmit the load of the slab. Slabs should be selected from several cardboards for homogenous accommodation of the slab tints. Temperature of enclosing space while gluing and 48 hours after should be no less than 5 C and no greater than 20 C.

Before gluing with the assistance of the leveler and patch we put 11 cm over floor in order to glue down the first row of slabs. Place glue punctually on previously cleaned slab and press evenly against the wall. Take off the excess of glue with the spatula. With the help of timber or metal saw cut appropriate sizes of slabs. After relating glue on the first bottom coat remove the patch and stick on the missing row of slabs. Apply corners for external and internal finish. Best effect is achieved when lying down slabs without fugue. After finishing preserve the work with “Alive color for rocks” which helps to maintain neatness from the firm STEGU®.